Wireless Bridge Point-to-Point Long Range Wireless Access with 20DBi High-Gain Antenna, 2.4G WiFi Bridge Repeater Supports 2600 feet Outdoor Transmission Distance, Air Ethernet Cable 4.0 out of 5 stars 37
GNS-1163AC is a complete PTP wireless link, operating at 802.11AC speeds for reliable wireless connection between your two locations. The High-Capacity 802.11AC Wireless Bridge will allow you to connect 2 buildings up to 1/4 mile (or more) apart. Unobstructed Line of sight is recommended to make use of the 80MHz channel width.
3PCS Wireless Bridge Kit, Gigabit Point to 2 Point Outdoor WiFi Bridges for Wireless Network Expansion, 5.8G Long Range High Speed WiFi to Ethernet CPE with 1000Mbps LAN Port, 16dBi 3Km (3 Pack) 23. 50+ bought in past month. $25999 ($86.66/Item) Save 6% with coupon. FREE delivery Thu, Dec 7.
Ubiquiti LOCO5AC NanoStation AC Loco airMAX Outdoor 5Ghz 13dBi WiFi 5 Point-To-Point PtP Link Kit, Pre-Configured (450Mbps AC) The Ubiquiti LOCO5AC NanoStation AC Loco Point-To-Point Kit gets maximum gain out of the smallest footprint. The high performance, and small form fact 931 IN STOCK. £100.74.
Wireless Bridge,CPE-452 Point to Point 5.8G Long Range Outdoor WiFi CPE with 14DBi High-Gain Antenna,24V PoE Adapter,2 LAN Port,for Network and Surveillance Range Extension,2-Pack. $ 195.00. Free Shipping. Direct from BFKK.
In the communications area, only Point-to-Point transmissions are allowed in the 24 GHz band. Therefore, this reduces the chances of interference. Licensing in the US forces relatively low power transmitters to be used in the 24 GHz band, thereby limiting operating ranges to typically less than 3 to 6 miles.
Try our affordably priced DIY Long Range P2P Wireless Ethernet Bridge kit which is a plug and play kit. It allows you securely project network access to another location using an existing wireless network. It creates a point to point wifi bridge using two directional antennas with pre-configured integrated radios.
Check cable integrity and connections Ensure that cable is 50 ohm type Run debug radio log verbose. Replace the cable if necessary. Be sure all outdoor connections are properly sealed, only use Coax-Seal or an equivalent. Control cable between PFP and transverter bad or disconnected.
Secure the wireless signal. Encrypt the wireless connection. From the web management console: Go to Wireless > Wireless Security > Security > WPA2-AES; WPA Preshared Key: enter a strong password; Click the Change button. Then click the Apply button. (For M devices, for AC devices simply click the Save button)
g2RY. 2hd96kjaau.pages.dev/2022hd96kjaau.pages.dev/1772hd96kjaau.pages.dev/7162hd96kjaau.pages.dev/3932hd96kjaau.pages.dev/5692hd96kjaau.pages.dev/7772hd96kjaau.pages.dev/7242hd96kjaau.pages.dev/8792hd96kjaau.pages.dev/2592hd96kjaau.pages.dev/1252hd96kjaau.pages.dev/6692hd96kjaau.pages.dev/3132hd96kjaau.pages.dev/422hd96kjaau.pages.dev/9522hd96kjaau.pages.dev/361
wireless point to point
